Endpoint Protection

I recently ran cleanwipe on a PC to remove a corrupt SEP install. After bringing it back up, I had no network connection. I checked in the device manager to see the yellow exclamation next to the teefer 2 miniport, I tried to uninstall but it wouldn't let me. Is there fix out there?

start -run-ncpa.cpl
look for teefer2drive
click uninstall :) 
should work
let me know the results/ 

If you run Cleanwipe though RDP it will corrupt your NIC Card drivers.
https://www-secure.symantec.com/connect/articles/how-restore-network-connectivity-if-cleanwipe-tool-removes-network-card-drivers 

I ran it locally

I will try tomorrow when I'm back in the office

Make sure you always use the latest version of Cleanwipe ..I guess the latest is Cleanwipe 5.0 

I would've but the first time I did it also killed my network connection. That was easier to fix though as I just uninstalled it and rebooted and it auto installed again. I've had not had an issue with Cleanwipe 3.0 though until now

 I am also faced same problem. This is a known issue .Any way I had put an idea for this .In future hey may fix this issue.This is the link to my idea 
SEP removal tool which will not corrupt network card drivers

@Rafeeq,
There is no teefer2 driver here

Is there a removal tool?

Yes there is a tool but for that you have contact support.
Please contact support on the local support number  and then they can help you with the tool

I actually resolved it by following Rafeeq's and AravindKM's posts.

There was no teefer2 driver in network connections just my normal connection. After looking at AravindKM's post, I just uninstalled my normal NIC and rebooted. Upon restart, it reinstalled and my connection was restored.

thats a good news, please do not run cleanwipe until and unless its necessary :) 

Yes, that will be my last ditch effort from now on :-)